PJ1000LIGHT

Compact amplifier 1.000W high redundancy.

COD.: PJ1000LIGHT
Potencia: 1.000W

Features

PRIMARY APPLICATION: uncompromised amplification power at a very attractive price. Ideal for medium power stations.
AMPLIFIER FEATURES: high-gain amplifier with very low input drive power requirement and adjustable power output from 10 to 100 %.
HARDWARE FEATURES: compact (525mm depth only) and indeformable thanks to the stainless steel chassis, in 3 rack units only.
USER-FRIENDLY FEATURES: four pushbuttons for user/device interaction and software that offers a simple, intuitive interface.
OPERATING EFFICIENCY: incorporate a PFC (Power Factor Corrector) power supply, that provides the utmost efficiency for enhanced energy saving and environmental protection, which added to LD-MOSFET technology ensure high efficiency, better than 70% across the bandwidth.
EASE OF MAINTENANCE: advanced module engineering ensures extreme ease of access and simple maintenance.
RELIABILITY/CONTINUITY: APC (Automatic Power Control) and Foldback protection ensure reliable operation under any operating conditions.
INTERFACE CONTROL: total control thanks to microprocessor easily programmed from menu with all key parameters displayed on LCD.
REMOTE CONTROL: electromechanically controllable and integrable into all digital ALTEL SISTEMAS telemetry systems.
REGULATORY COMPLIANCE: state-of-the-art technology in full compliance with EC, FCC and CCIR standards.

PJ1000LIGHT
Parameters	Conditions	U.M.	Value	Notes
GENERALS
Frequency range		MHz	87,5 ÷ 108
Rated output power		W	1000
Spurious & harmonic suppression		dBc	<75 (80 typical)	Meets or exceeds all FCC and CCIR rules
Working temperature		°C	-5 to +50
Working humidity		%	95	No condensing
Working altitude		mt	Up to 3000 *	* With adequate air evacuation system in site
POWER REQUIREMENTS
Power supply type			Monophase
AC Power input	AC Supply Voltage	VAC	230 ±15%
	AC Apparent Power Consumption	VA	1650
	Active Power Consumption	W	1630
	Overall Efficiency	%	Typical 63
	Power factor		0,998
	Connector		Terminal Block
DC Power input	DC Supply Voltage	VDC
DC Current	ADC
MECHANICAL DIMENSIONS
Phisical dimensions	Front panel width	mm / inch	483 / 19	EIA rack
	Front panel height	mm / inch	132 / 5,20
	Overall depth	mm / inch	550 / 21,65
	Chassis depth	mm / inch	500 / 19,69
Weight		kg	About 25
Cooling type		Forced, with internal fan
Acoustic noise		dBA	< 75	Leq 3 min @ 1 m
RF INPUT
RF Input	Connector		N type
	Impedance	Ohm	50
Driver power for rated output		W	11
Max input power before protection		W	25
RF OUTPUTS
RF Output	Connector		7/16″
	Impedance	Ohm	50
RF Monitor	Connector		BNC
	Impedance	Ohm	50
	Output Level	dBc	approx. -60
AUXILIARY CONNECTIONS
Interlock	Connector		2 x BNC	For remote power inhibition (short is RF off)
Service	Connector		DB9 F	Factory reserved for firmware program
I²Cbus	Connector		DB9 F
Telemetry interface	Connector		DB25 F
FUSES
On mains			2 External F 25 T – 10 x 38 mm
On services			1 Internal F 3,15 A 2 x 20 mm
On PA Supply			3 Internal F 16 A 10 x 38 mm
On aux VDE Socket			X